The transmitter is still in configuration, calibration, or warm-up mode. Complete the current menu process or wait for the timer to count down to return to normal monitoring.
Connect the internal sensor wiring harness to the main board terminal socket labeled SENSOR . First-Time Power Up and Configuration
The XNX utilizes a magnetic user interface, allowing you to navigate menus and change settings without opening the enclosure. This keeps the explosion-proof integrity intact during operation. Xnx Universal Transmitter Quick Start Guide
Apply the calibration gas via the calibration splash guard or cup. Monitor the display until the reading stabilizes. Select to accept the span value.
Scrolls through menus or adjusts numerical values. Escape (✖): Exits the current menu or cancels an action. The transmitter is still in configuration, calibration, or
: Must follow recognized national standards and be performed only by trained personnel.
Once initialized, the unit enters normal operating mode, displaying the target gas type, current concentration, and unit of measurement (e.g., ppm, %LEL, or %Vol). Non-Intrusive Interface Operation First-Time Power Up and Configuration The XNX utilizes
Test Transmission
Despite its reliability, the Xnx Universal Transmitter may occasionally require troubleshooting. Here are some common issues and troubleshooting steps:
Terminate the cable shield at the controller or power source end. Do not ground the shield at both ends to avoid ground loops.