If you need further help, please share details about your (magnetic or electric strike), your power supply model , or the specific programming step where you are encountering an issue. Share public link
The V2000-C RFID Access Control is a standalone, single-door system supporting card-only, PIN-only, and card+PIN authentication modes with up to 2,000 user capacity. Key features include a Wiegand 26 interface, Tamper alarms, adjustable door delay, and compatibility with 125KHz EM cards. For more detailed technical specifications, visit goldbridgesz.com www.goldbridgesz.com
By following this manual, you should be able to successfully install, configure, and operate your V2000-C RFID Access Control system. If you encounter issues not covered here, please consult your vendor or the original manufacturer's documentation. V2000-c Rfid Access Control User Manual
Issue 2: Card swiped, light turns green, but lock does not open
It is highly recommended to change the default code immediately. If you need further help, please share details
Enter Programming Mode -> Press 2 + [Read Card] + # .
Check your relay wiring. Ensure Fail-Safe locks use the NC wire and Fail-Secure locks use the NO wire. Enter Programming Mode -> Press 2 + [Read Card] + #
Proper installation ensures device longevity and prevents electrical shorts that could damage the access control system. Mounting the Device
If you lose the master code, you can typically reset the system using an internal jumper. Power off the device.