the power button for 15 to 20 seconds to drain remaining electrical charge from the capacitors. Leave the printer disconnected for at least 5 minutes.
: The printer will start programming (taking 1–2 minutes) and will reboot itself once finished.
Poor cable connection or failure to enter Forced Mode properly. firmware reset samsung ml 2160 2165 2160w 2165w
If the printer loses power during the update, it may become permanently damaged (bricked).
Keep both buttons pressed for 2–3 seconds, then release them together. the power button for 15 to 20 seconds
for about 15 seconds until the status light turns solid green, then release. This prints the Supplies Information Report. Document the following critical values from the pages:
| Model | Wireless? | Typical Firmware Versions (Bad) | Good (Downgrade) Version | |--------|-----------|-------------------------------|--------------------------| | ML-2160 | No | V3.00.01.35 or higher | V3.00.01.13 or lower | | ML-2165 | No | V3.00.01.35 or higher | V3.00.01.13 or lower | | ML-2160W | Yes (Wi‑Fi) | V3.00.01.35 or higher | V3.00.01.13 or lower | | ML-2165W | Yes (Wi‑Fi) | V3.00.01.35 or higher | V3.00.01.13 or lower | Poor cable connection or failure to enter Forced
Samsung laser printers utilize a built-in cryptochip located on the . This chip serves as a page counter rather than measuring actual toner mass. Once the programmed page quota is reached, the device displays a "Toner Empty" or "Replace Toner" warning and locks out further print actions.