Dtape Dt50 User Manual Pdf Today

Power on / Trigger single measurement / Continuous measurement (hold).

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Activates the Continuous Measurement (Tracking) mode. 2. Clear / Power Off Button (Clear / Off)

The DT50 measures from the of the device by default. To change to top or tripod thread : dtape dt50 user manual pdf

Stand back and aim the laser at the (the hypotenuse) and press MEAS .

If you notice your measurements are consistently off by a few millimeters, you can manually calibrate the sensor accuracy without sending it back to the factory. Turn the device .

Instead of manually multiplying numbers, let the internal chip do it for you: Area ( M2cap M squared Ft2cap F t squared Power on / Trigger single measurement / Continuous

Allows for the compounding of multiple measurement results. Standard Operation Procedures

Use a white target sheet or piece of paper on the destination surface. Ambient light is too bright

Indirectly measures height or depth by taking two or three reference points. If you share with third parties, their policies apply

Complete Guide and User Manual for the DTAPE DT50 Laser Measure

I can provide specific instructions to get your measurements back on track! Share public link

Just as the tool touches the solid brick wall, the display doesn't stop. It doesn't show "Err." Instead, it flashes According to the DTAPE DT50 user manual , the laser has a maximum range of 165 feet (50 meters)

Power On / Single Distance Measurement / Continuous Measurement (Long Press).