Getting your HVAC system up and running with a doesn't have to be a headache. Whether you’re a DIY enthusiast or just want to understand what your technician is doing, this guide breaks down the essential steps found in the installation manual. Before You Start: Safety First
Press the button to verify that the indoor unit responds immediately. 5. Field Settings & Configurations
Choosing the correct location prevents faulty temperature readings and system inefficiencies. Recommended Locations Approximately 1.5 metres above the floor level.
Hook the top tabs of the front assembly into the top slots of the mounted rear plate. Pivot the lower half of the controller downward. daikin brc1c51 61 installation manual
: Connect the control terminals P1 and P2 on the remote controller to the terminals P1 and P2 on the indoor unit.
4.5 to 5 feet (1.4m – 1.5m) from the floor, on an interior wall.
What (e.g., FXFQ, FXSQ) are you connecting? Getting your HVAC system up and running with
Strip approximately 6–7 mm of insulation from the ends of the 2-core control wire. Pass the wire through the rear plate opening.
Getting your Daikin BRC1C51/61 remote controller set up correctly is essential for managing your system efficiently. This wired controller is commonly used with Daikin's VRV and SkyAir systems.
Tighten the terminal screws firmly, ensuring no bare copper wire strands protrude from the block. Step 4: Securing the Rear Mounting Plate Hook the top tabs of the front assembly
This comprehensive guide covers everything found in the official installation manual, including mounting specifications, wiring diagrams, and field settings. 1. Pre-Installation Specifications
: If you are using two remote controllers to operate the same indoor unit (e.g., in large rooms), you must assign one as MAIN and the other as SUB .
Press and hold the for 4 seconds or longer while the system is in normal mode.
Always turn off the main power supply to the indoor unit before starting. Electrical shock can cause severe injury or damage the equipment.