Commax Dp-ra01 Installation Manual Review

Lift the indoor handset receiver to start a conversation. Check for audio clarity from both ends. You can modify incoming ring volume using the sliding dial on the side of the handset.

: Do not handle the power cable with wet hands to prevent electric shock. Weather Hazards : Do not install the product during lightning or thunder.

While this guide covers 95% of installation scenarios, Commax occasionally revised PCB layouts. For the exact : commax dp-ra01 installation manual

Turn off the main AC circuit breaker before handling any open wiring connections.

: Align the grooves on the back of the DP-RA01 unit with the hooks on the wall bracket. Slide the unit down firmly until it locks into place. Lift the indoor handset receiver to start a conversation

Have an assistant press the call button on the outdoor door station. The DP-RA01 should emit an electronic chime. Pick up the handset and verify that clear, two-way audio communication is established.

Follow these steps to safely mount and secure your indoor and outdoor intercom hardware. Step 1: Turn Off the Power : Do not handle the power cable with

If you are installing a second handset in another room, this is how you enable intercom functionality:

The power supply unit provides power to the entire system. Follow these steps:

Secure the bracket to the wall at a comfortable height (typically about 1.45m from the floor) using the provided screws. Ensure the product is at least 10cm away from the wall if it generates heat to allow for proper ventilation. Wiring Connections Door Station to Room Station